This appliance shall be installed in accordance with:• Manufacturer’s Installation Instructions• Current AS/NZS 5601 AS/NZS 3000 • Local Regulati
Rinnai 8 RF800 OIMThis page is intentionally blank
Rinnai 9 RF800 OIM Operation Table of Contents 1Installation Safety 10Specications 11Dimensions 11Gas & Electrical Supplies 12Cleara
Rinnai 10 RF800 OIMINSTALLATION SAFETYWARNINGThis appliance must be installed by a suitably qualied person in accordance with local co
Rinnai 11 RF800 OIMSPECIFICATIONSModels: RF800E(N/P)Burner Media: Ceramic Logs / Coals and Granules Ceramic PebblesGas Types: Natural Gas
Rinnai 12 RF800 OIMGAS & ELECTRICAL SUPPLIES Gas SupplyA suitable gas supply needs to be provided to the left hand rear corner of the installati
Rinnai 13 RF800 OIMMANTLES, SURROUNDS, RECESSES & HEARTHSMantlesA timber mantle may be installed above this appliance but must be within the grey
Rinnai 14 RF800 OIMVENTILATIONIMPORTANTThis appliance is a decorative ame effect appliance, the space or room in which the unit is i
Rinnai 15 RF800 OIMENGINE INSTALLATIONTimber Cavity DesignIMPORTANTThe appliance and ue need to be installed before the wall can be lined! It
Rinnai 16 RF800 OIMMASONRY CAVITY DESIGNNOTERemember that both gas and electricity are required within the cavity before the appliance is installed (
Rinnai 17 RF800 OIMPreparation of the EngineIf the exi ue adaptor is to be used then there are modications that need to be made to the engine.1.
Rinnai i RF800 OIMCongratulations on the purchase of your RF800 Decorative Gas Log Effect applianceWe trust you will have many years of enjoyment fr
Rinnai 18 RF800 OIMAPPLIANCE GAS CONNECTION & COMMISSIONINGOnce the engine has been installed and xed to the building the gas and elect
Rinnai 19 RF800 OIM4. Low Pressure Setting: Turn ‘OFF’ the power to the POV by separating the connector of the two yellow wires that power the POV.
Rinnai 20 RF800 OIMPILOT BURNER PERFORMANCEWhen operating at its best, the pilot burner will produce a sharp blue ame with a light blue inner cone.
Rinnai 21 RF800 OIMBURNER MEDIA INSTALLATIONWARNINGONLY use the burner media supplied by the manufacturer in this appliance. DO NOT BURN WOOD OR ANY
Rinnai 22 RF800 OIMFINAL CHECKSCheck that the appliance operates properly in all modes (high & low gas rates, fan high & low.) and make sure
Rinnai 23 RF800 OIMWIRING DIAGRAMPILOTACTIVEYLGRCONTROL BOX(Millenium)GAS CONTROL 12 PIN PLUGFUSE3 AMPBRNCOLOURWH WHITEBLK BLACKYL YELLOWRD REDBLU BL
Rinnai 24 RF800 OIMINSTALLATION NOTESWrite any comments on the installation here and leave with the owner for future reference.
Rinnai 25 RF800 OIMThis page is intentionally blank
Rinnai 26 13309 - RF800 OIM Issue 2 27/08/14CONTACTSHead Office 100 Atlantic Drive,Keysborough, Victoria 3173Tel: (03) 9271 6625Fax: (03) 9271 662
Rinnai 1 RF800 OIM Before You Start 2Safety 3Safety Devices 4Features 5Control Panel Operation 5Remote Control Operation 6Operational Safety 6
Rinnai 2 RF800 OIMBEFORE YOU STARTINSTALLATION REQUIREMENTSThis appliance MUST BE installed by an authorised person.The installation MUST conform to
Rinnai 3 RF800 OIMSAFETYWARNINGDO NOT OPERATE THIS APPLIANCE WITHOUT READING AND UNDERSTANDING THESE INSTRUCTIONS.Taking time to familiarise yoursel
Rinnai 4 RF800 OIMSAFETYIMPORTANTDO NOT sit or lean against the heater.DO NOT allow children or elderly persons to sleep in the warm air discharge f
Rinnai 5 RF800 OIMFEATURESCONTROL PANEL OPERATIONTo operate your appliance for the rst time, ensure that the gas supply is on and that the applianc
Rinnai 6 RF800 OIMREMOTE CONTROL OPERATIONNOTEHere are a few things you should know about your remote control to keep it working at its best:• The r
Rinnai 7 RF800 OIMBURNER MEDIAThe burner media MUST BE positioned correctly by the installer. It is not intended that these are re-positioned by the
Kommentare zu diesen Handbüchern